Internal Pipe Blasting Tools
Internal Pipe Cleaning Tool.For pipe up to 36" 1.0.
Internal Pipe Cleaning Tool .For pipe up to 36" 1.0.
Hollo - Blast Jr. 3/4" -2" (19 mm - 50 mm)
Hollo - Blast. 2"- 12" (50 mm - 300 mm)
Roto Blast. 8" - 36" (200 mm - 900 mm)
CoverCat - High capacity PFP application Machine
CoverCat produces the largest 450 series units for
application of high volumes of PFP materials in the largest
of fabrication facilities
The system uses 3 phase electrical power at 220V or
400/440V (to be specified).
Hose lengths to 60 meters plus remote mix manifold
On rough, porous surfaces like stucco and concrete block many
contractors apply the coating with a sprayer and then back-roll
it into the surface. It can be messy (lots of overspray) and time
consuming (two workers). Now imagine what it would be like to
spray AND roll at the same time. You save time and make money.
Internal Pipe Coating Tools
The Speed Blast Internal Pipe Coater- II & III are designed to coat the inside of pipes quickly and evenly without the need to rotate the item. Both machines comfortably handle most long life heavy duty protective paint coating systems. Either unit simply couples to a suitable airless spray machine of minimum 45: 1 ratio.
n operation a rotating head, powered by an air motor throws paint by centrifugal force at an evenly metered flow against the surface. Pipe coater is manually pulled through the pipe at a pre-determined speed based on paint film thickness and type of coating.
|Internal pipe coater -I
spara pattern for pipes
2"-6"I.D>(50mm - 150mm))
|Internal pipe coater II
6" - 12" I.D (150 mm - 300mm)
|Internal pipe coater III
8" - 36" I.D (200 mm - 900mm)